If the drain pump motor is not working the dishwasher won t drain.
Electrolux washer no water draining.
Correct the air leak problem.
The drain pump uses an impeller to force water through the drain hose.
To determine if the drain pump is defective check the pump motor for continuity using a multimeter.
You ll need to pull the washer forward and turn the water off to the washer.
If a lid switch does not have continuity replace it.
If they are clogged flush them out.
Is the washer leaking water.
Replace the pressure sensor.
Check the little filter screens where the fill hoses connect to the back of the washer.
If necessary remove the washer s main access panel agitator drum shield and drum to access the clogged area.
Remove the drain hose attached to the water pump and check the pump and hose for obstructions.
Also this message comes up before the spin cycle and the machine just stops washing.
Go to step 2 2.
Go to step 3 3.
If this did not correct the problem go to step 4 4.
To determine if the lid switch assembly is defective use a.
The lid switch assembly prevents the washer from spinning when the lid is open.
Replace the main control board.
Turn the water on to make sure you have good water pressure from both hot and cold water lines.
Disconnect the fill hoses from the back of the washer and put them in a 5 gallon bucket.
I just purchased an electolux washer and dryer model eiflw55h and before any of the wash cycles end a message comes up that reads no water draining.
Turn the water off and remove the hoses from the back of the washer.
If your washer spins but can t pump water through the hose an item of clothing may be stuck in the line.
Is there an air leak in the air bell system.
If the motor does not have continuity or if is getting power but won t run replace the drain pump.
If the lid switch assembly fails the washer will not drain.
If everything checks good you just need to replace your electronic water valve because it has failed and isn t letting any water into the washer.