Electrolux Washer Door Lock Error

Door closed sensing failure.

Electrolux washer door lock error.

Also on any cycle before the spin cycle it just stops and unlocks the. The door lock solenoid will deactivate and the loading door can be opened. Door incongruence between door line and door sense. When the door is opened the drum light should turn on if so equipped.

If the door lock is damaged or does not latch properly replace it. Check if there is water in the machine. Door lock device failure. If you re in the middle of a cycle turn the dial or press the button to pause or end the cycle.

The door lock can fail either mechanically or electrically. Check wire connection between door lock and main control board. If good replace the door lock. If the door lock is defective the washer may stop mid cycle.

If the washer door is not latched shut the door switch prevents the washer from operating. Once the washer door is closed the washer can begin operating. When the door lock dies on these machines it fries the electronic board so if you door lock plays up turn the power off and unplug your machine from the po. Washer was not completing cycle and unlocking door which left clothes stuck so after disconnecting and reconnecting machine it reset computer and now works f.

Line door sensing failure. On some models if there is a problem with opening the door and the display is off turn on the washing machine and make sure the door lock icon is not active. In this video we take a look at a frigidaire washer in which the door lock light was flashing and it was not spinning. Wait 5 6 seconds to see if the door unlocks.

Affinity diagnostic mode newer models turn the program knob 6 clicks from the start position. The door lock will activate and the washer will fill then tumble. Turn the washing machine off and unplug it. If there is water in the machine the door cannot be opened.

If problem is not corrected replace the main control board.